• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

The system proved the feasibility of AC electric power transmission over long distances. Long-distance communication takes place over undersea communication cables. Electric cables are made of materials with high electrical conductivity (usually copper, but there are also cables made of aluminum).Electric cables are made up of:- Electrical conductor: the conductor is the material through which electrical charges move.- Insulation: insulation is an insulating layer that covers the conductor so that the electrical current does not escape and can only travel through the conductive material (copper or aluminum).- Filler layer: The filler layer separates the conductor and the insulation. Conductor type: There is the insulated wire conductor, the bare wire conductor, the flexible cable or strand conductor.- Coating properties: there are several types of coatings and there is even a nomenclature to differentiate them.- Type of insulation: electrical cables can be thermoplastic or thermoset. The first thermoplastic used was gutta-percha (a natural latex) which was found useful for underwater cables in the 19th century. SPT (Service parallell thermoplastic): This nomenclature is used to refer to a cord that is made up of two flexible and parallel cables with plastic insulation. This type of cable is also called a duplex cord.

Ribbon cable is a type of wiring where each wire conductor is attached at its side, creating a flat ribbon-like wire. Flat connectors on each end allow the wire to connect at two points while taking up a minimal amount of space. Much like "ribbon cable," its signature shape has earned names like "flat cable" and "multi-planar cable." The purpose of this arrangement is to maximize the potential number of wires while minimizing the footprint, which allows for many wires to fit in tight spaces. Such facilities are nuclear, coal or hydroelectric, while other energy sources such as concentrated solar thermal and geothermal power have the potential to provide firm power. The power cable is made of three main components, namely, conductor, dielectric, and sheath. Unbalanced inductance among the three conductors is problematic because it may force the middle line to carry a disproportionate amount of the total power transmitted.

The study measured the electric field strength at the edge of an existing right-of-way on a 765 kV transmission line. LS (Low smoke): This electric cable has a low content of polluting gases.6. Single-wire earth return (SWER) or single-wire ground return is a single-wire transmission line for supplying single-phase electrical power to remote areas at low cost. Series resistance and shunt conductance are considered to be distributed parameters, such that each differential length of the line has a corresponding differential series impedance and shunt admittance. The first solution to these problems is to keep cable lengths in buildings short since pick up and transmission are essentially proportional to the length of the cable. HVDC links can be used to control grid problems. Wind turbines, vehicle-to-grid, virtual power plants, and other locally distributed storage and generation systems can interact with the grid to improve system operation. Many speaker manufacturers will specify choosing larger gauge wire if running longer distances of wire or wiring up higher-ohm systems.

When choosing speaker wire, consult the manufacturer's instructions closely. In order to work better, some colors have been established for the insulators to better identify their function.The colors of the electrical cable insulation are as follows:- Green and yellow wire: it is the ground wire, with which the ground connection is made.- Blue wire: it is the neutral wire. However, unlike armored cables, metal-clad cables feature a full-size designated ground wire, while armored cables rely on a combination of the metal jacket and a thin wire or strip for grounding. MC cables also feature plastic sheathing around the internal wires, while armored cable uses paper. Like armored cables, metal-clad cables feature metal sheathing that offers protection to the wiring, allowing it to be installed in areas where it may be vulnerable to damage. For example, small wiring that can handle low-voltage applications like landscape lighting isn't qualified to carry the load required for a water heater. Under excess load conditions, the system can be designed to fail incrementally rather than all at once. These inscriptions are abbreviations that mean the following:You can identify the type of insulation that a cable has in the inscriptions that appear on it, they are abbreviations of English.

When you loved this article and you wish to receive much more information with regards to what are electric cables please visit our own webpage.